Installation & Wiring

Before installation

Confirm the product model, included cable lengths, rear camera type and intended power method. Test every camera and the memory card before permanently routing cables.

Mounting the main unit

Choose a position that preserves the driver's view and does not interfere with sensors, mirrors, airbags or vehicle controls. Clean and dry the glass before applying an adhesive or suction mount.

Routing cables

Keep cables away from pedals, steering components, sharp metal edges, moving trim and airbag deployment paths. Do not force cables into an airbag area. A professional installer is recommended when vehicle trim or electrical connections are unfamiliar.

Rear and additional cameras

Check image orientation before final mounting. Exterior cameras must use the supplied weather-resistant connections and appropriate cable path. Backup-trigger wiring varies by product and vehicle.

Parking mode

Parking recording normally requires a compatible IIWEY hardwire kit, OBD power solution or supported external battery. Confirm the kit for the exact model and use low-voltage protection. Incorrect wiring can discharge or damage a vehicle battery.

Final checks

• Format the compatible memory card in the camera.
• Verify every channel, date, time and recording resolution.
• Confirm cables do not obstruct airbags or controls.
• Test ignition on/off behavior and parking mode.
• Save a short recording and confirm it plays correctly.

For model-specific instructions, contact support@iiwey.com with the exact model and vehicle details.